Step 1: Build Support Frames and Attaching Metal Brackets - Continued

"Square" the Support Frame by adjusting the outside members until the distance between opposite corners is equal, as shown in Diagram 4. After the Support frame is "squared," center and secure the remaining piece (B) with three - 2 1/2" deck screws, as shown in Diagram 5.

Secure two additional 2 1/2" deck screws at each of the four corners of the Support Frame.

Metal Brackets
Simpson Strong-Tie® LUS26Z Double Shear Hanger Z-Max	Simpson Strong-Tie® LS50Z Skewable Angle Bracket Z-MAX

Attach a metal corner bracket (Simpson Strong-Tie® LS50Z or similar) in each of the outside corners of the Support Frames. Next, attach a metal joist hanger (Simpson Strong-Tie® LUS26Z or similar) to each end of the (A) and (B) 2"x6" support board. A slight bend in the corner brackets and joist hanger will be needed to fit the angles of the Support Frame, as shown in Diagram 5.

Repeat until all Support Frames have been constructed.

All brackets and hangers should either be Hot Dipped Galvanized, ZMAX Galvanized products or similar products designed for exterior pressure treated lumber.Use the recommended nails or connectors for each product.