well i have purchased the material for the splash deck. I am only doing 7 sections on a 24' round pool. i am having the hardest time figuring out how to cut the angles for the support. i feel like an idiot, but I am also wasting wood and need help. I did finally angle the miter to 10 degrees, but then my measurements were off. I measured according to the plans, but when I cut my inside measurement was what I was trying to get my outside to be. Is this making any sense? Is there an easier way to accomplish this task ???????????????//PLEASE!!!

You will have to add the 10 degree angle in your measurement, then cut from the out side corner of the new length with the angle, in toward the original length. We don't add the angle in the measurement, because the angle varies depending on pool size.

Hope this helps.

Deckman